
EV charging and power electronics
Charger controllers, relay and contactor control, energy metering and load management, designed for mains voltages and electrical safety.
Most of our industrial electronics design work falls into four fields. In each, the device has to run for years in a cabinet, a charger or a machine, and meet the standards that apply to it. We know those standards and the interfaces used there, so a design starts from the right constraints.

Charger controllers, relay and contactor control, energy metering and load management, designed for mains voltages and electrical safety.

Custom controllers, I/O and interface boards, and front panels for DIN-rail cabinets, speaking Modbus, CAN and Ethernet.

Drivers and controllers for brushed, brushless and stepper motors, with the protection and feedback a machine needs.

Machine controllers, payment interfaces, sensor boards and connected data loggers that report from the field.
Electronics development by industry means more than a list of markets. In each field we design the board, the firmware and the enclosure together, build the prototypes, and test them against the conditions the device will meet in service. If your device belongs to a field not listed here, the same methods apply: send us the requirements and we will say plainly whether we are the right partner.
Each industry page lists the devices we design there, the interfaces and standards involved, and the services a typical project uses, so you can see how your device would be handled before you write to us.
