An electronics design company in Chisinau, working for clients across Europe

Proto Lab AM is an electronics design company in Chisinau, Moldova. We design, build and test electronic devices for product companies, startups, OEMs and system integrators across Europe. Our work runs from the first requirement to a tested device and the files needed to manufacture it.

Bench test of a board with an oscilloscope and a laboratory power supply

Who we are

Proto Lab AM SRL is registered in the Republic of Moldova under IDNO 1022600023233, with its workshop and office at Studentilor 9/11, Chisinau.

The people who design a device also build and test the first units, so what is learned on the bench goes straight back into the design. We work in English with our clients, and also in Romanian and Russian.

SMT assembly bench with a panel of prototype boards, inspection microscope and soldering station

Open charger enclosure with the controller board, charging socket and mains power wiring in place

What we work on

Most of our devices go into demanding places: EV chargers and power cabinets, industrial control panels, motor drives, and vending machines and remote sensors that report over cellular networks. They switch mains voltages, run for years without attention, and must pass CE marking. That is the work we are organized for. See our services and the industries we design for.

How we check our work

Electronics engineering quality is mostly a matter of checking at every stage, not only at the end. These checks apply to every project:

  1. Design review

    Schematics and layouts are reviewed against the requirements, the component datasheets and the rules of the factory that will build them, before anything is ordered.

  2. Design for manufacture and test

    Boards are released with fiducials, test points, polarity marks and a bill of materials with alternatives, so they can be built and tested at volume.

  3. PCB assembly inspection

    Every board we assemble is inspected for solder joints, alignment and polarity, and checked for shorts and opens before it is powered.

  4. Bring-up and functional tests

    First units are brought up step by step and tested against a written procedure, which later becomes the production test.

  5. Pre-compliance

    EMC and electrical safety are checked in our lab before a device goes to an accredited laboratory.

Equipment and tools

We design in Altium Designer and KiCad, model enclosures in SolidWorks and simulate circuits in LTspice.

Partners

Production runs, typically from 50 boards, are built at partner factories in the EU and China. We prepare the manufacturing files, inspect the first articles and test the delivered units, so you deal with one supplier from design to delivery.

Formal certification is carried out by accredited laboratories in Moldova, Romania and the EU, which we prepare devices and documents for.

Why clients in Europe work with us

Eastern European Time

We work the same hours as Bucharest, one hour ahead of Berlin and Paris, so meetings and answers fall inside your day.

CE knowledge

We design for the EMC Directive, the Low Voltage Directive and the Radio Equipment Directive from the first schematic.

Cost

Our engineering rates are below Western European ones, for the same deliverables.

How we protect your project

We sign a non-disclosure agreement before you send design files. Work is agreed in writing, in stages, and each stage ends with a result you can review. You receive the complete design source and manufacturing package, so your product never depends on us to be built or changed.

Schematic and matching PCB layout of a controller board in the design tool