Box build assembly for finished electronic devices

Our box build assembly takes assembled boards the last step: into the enclosure, wired, labeled and tested as a device someone can install. We build prototypes, demonstration units and pilot batches for field trials, so the first units your customers see look and work like the product you intend to sell.

Display board fitted into the lid of a sealed enclosure, with the base and cut-outs beside it

Why the last step matters

Fitting electronics into a housing looks simple and often is not. This is where a connector misses its cut-out by a millimeter, a display sits crooked behind its window, a cable rubs on a sharp edge or a board runs hot because nothing lets the heat out. Finding that on five pilot units costs a few hours. Finding it on five hundred costs a recall. Electronic enclosure assembly done by the engineers who designed the device is the cheapest place to find these faults.

LED matrix boards next to the black enclosures they are fitted into

What a box build includes

Mechanical assembly

  • Mounting boards on standoffs, rails or directly to the housing
  • Aligning connectors, buttons, LEDs and displays with the front panel
  • Fitting gaskets, thermal pads, strain reliefs and cable glands
  • Closing with screws, clips or adhesive, as the design specifies

Wiring and harness integration

  • Power and signal wiring cut, terminated and routed to a drawing
  • Connecting displays, batteries, sensors, antennas and control panels
  • Keeping mains and low-voltage wiring apart, with the insulation the safety standard requires
  • Checking cable runs against shielding and clearance requirements

Finishing

  • Serial-number labels, QR codes, rating plates and warning labels
  • A final check that every part is seated and every fastener tight
  • Functional testing of the complete unit, on request
  • Packing for shipment or for delivery to a test laboratory

Enclosures we work with

We assemble into ready-made housings from established suppliers (DIN-rail cases, wall-mounted IP-rated boxes, desktop and handheld cases) as well as custom enclosures that are 3D printed or CNC machined. If you do not have an enclosure yet, our enclosure design service can select or design one, with the cut-outs and mounting points matched to the board.

Controller board seated in a DIN-rail enclosure base with an M12 connector

Electromechanical assembly for pilots and trials

Many units we build are meant for a specific moment in a product's life:

Each of these needs a unit that matches the production design, so the lessons learned from it carry over.

Validation

Checking how the device feels, mounts and is used.

Demonstrations

A real unit for investors, customers or a trade fair.

Environmental trials

Thermal and mechanical tests in the real housing.

Field pilots

A small fleet installed at customer sites.

Pre-compliance

Safety distances, insulation and shielding checked in the final assembly, before the device goes to compliance testing.

What you receive

Finished, labeled devices in their enclosures

An assembly record per unit: serial number, board revisions, any deviation from the drawing

Test results for each unit, when functional testing is included

Read more

A list of issues found during assembly, with the change we recommend for each

Assembly drawings and work instructions, so a factory can repeat the build

Wiring and harness work in progress on the assembly bench